METHOD OF APPLICATION |
| |
| 1. |
|
On bare surface:- The surfaces are cleaned, roughened, using 00 emery paper to make it free from cement laitance followed by application of Acrylic putty followed by rubbing & if required another coat of putty & making it smooth. On the above surface acrylic primer is applied & allowed to cure form min. 6-8 hrs. |
| 2. |
|
Over the above 1, 2 or 3 coats of 2K Water Borne Polyurethane Anti Graphitic Coating for Wall & Floors shall be applied. |
| 3. |
|
The thickness for the 1st coat shall be approx. 25 – 30 micron and further coats shall be 20 ± 5 micron. The total thickness for 3 coats shall be 60 ± 5 microns & the total material requirement shall be approx. 300 Gms for 3 coats per sq. mt. |
|
| |
RECOMMENDED SYSTEM
FOR WALLS
|
| Surface Requirement: Should be hard, uniform & smooth. If require water soluble acrylic putty can be used for surface preparation on the wall. |
| |
| 1. |
|
Primer - 1K WB Swiss 555A / 2K WB Epoxy |
| 2. |
|
Primer for 2K Epoxy systems. |
| 3. |
|
Putty – 551 WB Swiss make / Epoxy Putty (if required). |
| 4. |
|
Top Coat – 2K WB Polyurethane Swiss 555 |
| If required for floor, PU self-leveling or Epoxy floor or over PU Single pack moisture cured Primer, PU Screed Solvent, and PU Self Leveling. |
| |
|
|
|
| The information has been carefully compiled from the experience gained in the field conditions and detailed laboratory testing. However the product performance and it’s suitability for the customers purpose depend upon the particular conditions of the use and the material being coated. We recommend that customers satisfy themselves that each product meets their requirements in all respects before application. Since we cannot anticipate or control the conditions under which our products are used, it is not possible to guarantee their performance. All sales are subject to our standard terms and conditions of sale. |
| |
